Circuit Current For Which Designed
Dc
Dielectric Withstanding Voltage In Volts
1500.0
Center To Center Distance Between Mounting Facilities Parallel To Length
6.050 inches
Center To Center Distance Between Mounting Facilities Parallel To Width
0.725 inches
Overall Height
6.690 inches
Overall Width
1.520 inches
Mounting Hole Diameter
0.138 inches
Scale Division Quantity
40 single indicator single range
Environmental Protection
Dustproof
Furnished Items And Quantity
Nuts 6, loose washers 4; machine screws 4, split-ring lockwashers 4
Indicator Type
Dial w/pointer
Installation Design
Panel
Mounting Arrangement Style
Four hole/stud rectangular/square
Dial Scale Marking Color
Black single indicator single range
Accuracy In Percent
-1.0/+1.0 at full scale single indicator single range
Meter Depth Behind Mounting Flange
5.760 inches
Meter Body Width Behind Mounting Flange
1.225 inches
Movement Type
Moving coil, permanent magnet
Background Color
White single indicator single range
Pointer Color
Red single indicator single range
Mounting Facility Type And Quantity
4 unthreaded hole
Scale Graduation Type
Linear single indicator single range
Measurement Range
+0.0/+200.0 microamperes, dc single indicator single range
Scale Selection Method
Terminal
Meter Body Height Behind Mounting Flange
5.435 inches
Features Provided
Zero adjuster and self-illumination facility
Movement Suspension Method
Jewel pivot base
Circuit Attachment Method And Quantity
2 threaded stud
Special Markings
Positive shall be marked on rear upper terminal of ammeter; there shall be a identification plate with a marked quantity measured by the ammeter
Nuclear Hardness Critical Feature
Nonhardened
Style Designator
Rectangular flush mtg
Test Data Document
81349-mil-s-901 specification (includes engineering type bulletins, brochures, etc., that reflect specification type data in specification format; excludes commercial catalogs, industry directories, and similar trade publications, reflecting general type data on certain environmental and performance requirements and test conditions that are shown as "typical", "average", "", etc.). And 96906-mil-std-108 standard (includes industry or association standards, individual manufactureer standards, etc.). And 96906-mil-std-167 standard (includes industry or association standards, individual manufactureer standards, etc.). And 23905-70000+06901-77 drawing (this is the basic governing drawing, such as a contractor drawing, original equipment manufacturer drawing, etc.; excludes any specification, standard or other document that may be referenced in a basic governing drawing)
